RIKON Power Tools 34-250 - Manual (Page 8)

8
Assembly
Installing the Riser Block
The 34-250 Mortising Machine will accomodate workpieces up to 4-1/4” as preassembled by
the factory. A riser block 1-3/4” tall is provided separately so pieces up to 6” can be mortised.
Below are the steps necessary to add the riser block. NOTE: The fence adjustment knob will
become inoperable with the riser block installed.
3. Install the feed handle to the notched hub
using the M10-1.5 x 15 Allen bolt and spring.
(Fig.03)
1. Locate the riser block, four hex bolts M8-
1.25 x 80 , and the long hold down support
rod. (Fig.04)
Fig.03
Fig.04
2. With the aid of another person, separate the
column from the base by removing the four
hex bolts M8-1.25 x 25. (A-Fig.05)
Fig.05
A
A