RIKON Power Tools 50-120 - Manual (Page 11)

11
End Sanding on the Sanding Belt
To sand the end of a long workpiece, it is recom-
mended to sand with the belt in the vertical position.
1. To raise the belt to the vertical position, follow the
instructions in “Positioning Belt Bed” on the previous
page.
2. Install the worktable assembly.
3. Move the work evenly across the sanding belt.
(See Fig. 16)
Sanding Curved Edges
Always sand inside curves on the idler drum as
shown.
(See Fig. 17)
Warning: Never attempt to sand the ends of a
workpiece on the idler drum, applying the end of the
workpiece to the idler drum could cause the workpiece
to fly up and result in an injury.
Always sand outside curves on the left side of center
on the sanding disc as shown.
(See Fig. 18)
Warning: Applying the workpiece to the right side of
the disc could cause workpiece to fly up (kickback)
and result in an injury.
Sanding Small End Surfaces on the Sanding Disc
Note: Use of a miter gauge is recommended for this
operation.
Always move the work across left side of center on
the sanding disc face as shown.
(See Fig. 19)
Warning: Applying the workpiece to the right side of
the disc could cause workpiece to fly up( kickback)
and result in an injury.
Fig. 16
Fig. 17
Fig. 18
Fig. 19