RIKON Power Tools 50-120 - Manual (Page 7)

7
Fig. 06
Fig. 07
Fig. 05
Fig. 04
Installing the Disc Table Assembly
Warning: To avoid jamming the workpiece or fingers
between the table and sanding surface, the table edge
should be a maximum of 1/16 in from sanding
surface.
1. Use two M6x16 pan head screws to fasten the table
support mount to the front of sander.
2. Place the support table w/scale onto the table
support mount.
3. Put a 6mm flat washer on the table lock knob, and
place the knob into the tilt scale plate and mount. Hand
tighten it only at this time. (See Fig. 04)
4. Place the table onto table support; align the four
screws which are preassembled under the table with
the holes of table support. (See Fig. 05)
5. Put the external lock washer and hex nut onto the
screws, and tighten.
6. Adjust the table and retighten the table lock knobs.
7. Loosen the four M6 hex nuts under the table.
8. Use a 1/16 inch drill bit as a spacer. Place the drill
bit between the disc and the front edge of the table.
Hold the table against the 1/16 inch drill bit and tighten
the four M6 hex nuts. (See Fig. 06)
Leveling Table Assembly
Warning: To avoid injury from accidental start, make
sure tool is unplugged before making any
adjustments.
1. Using a combination square, check the angle of
work table with the disc. (See Fig. 07)
2. If the table is not 90 degrees with the disc, loosen
the table lock knob screw and tilt table.
3. Adjust worktable square to the disc and retighten
the table lock knob.
4. Adjust the pointer to the zero mark on the scale
plate.