RIKON Power Tools 50-120 - Manual (Page 6)

Fig. 01
Fig. 02
6
Assembly
Securing Sander Base Assembly to Workbench
The sander base must be secured before using.
Attach a large C-Clamp to each side of the sander
and the workbench. Or, permanently mount following
the instructions below:
1. Place the sander on the workbench in its final
operating location.
2. Place a pencil through the mountong holes of the
sander base (42) and mark the hole locations on
workbench.
3. Remove sander and drill four 3/8 inch holes through
the workbench.
4. Align sander base over holes and secure using four
5/16 inch screws (or larger) and hex nuts.
(See Fig. 01)
Mounting Sanding Disc and Guard
1. Locate sanding disc (22) and peel backing off
disc.
2. Align perimeter of sanding disc over plate. When
aligned, press disc firmly onto disc.
3. Position disc guard (27) onto lower portion of
sanding disc so that the mounting holes align.
4. Using a Phillips screwdriver, fasten two pan head
screws (found in parts bag) through disc guard.
(See Fig. 02)
Installing the Belt Table
1. Place the work table for belt on the work support.
2. Insert two countersink head screws through work
table and the work support slot.
3. Put a 6mm washer and a wing nut on the screw
and tighten. (See Fig. 03)
Fig. 03