RIKON Power Tools 10-050 - Manual (Page 11)

11
Leveling Fence to the Saw Table
4. View the fence from the left side of the saw
(Figure 12). Look for the space between the
table and the fence bottom to be equal along
the entire length of the fence.
5. If the fence is highest at the rear of the table,
lower the nylon pad at the rear of the fence using a
10MM wrench.
6. If the fence is highest at the front of the table,
raise the two nylon pads on the front of the fence
with a
4MM L wrench. Raise each side equally as it
could cause the fence to be out of square with the
table. (C,D, Fig. 13.)
Figure 12
Figure 13
Assembly
Should be equal of
entire length of fence
C D