RIKON Power Tools 10-050 - Manual (Page 14)

Blade Installation and Removal
Please disconnect saw from the
power source. Make sure to use caution while work
with or around saw blade.
1. Raise the blade arbor and make sure the arbor
is at the zero degree position.
2. To install during initial assembly, remove the
arbor nut (A, Fig. 21) and fl ange (B, Fig. 21) from
arbor.
3. Place blade (C, Fig. 21) on arbor shaft making
sure teeth point down at the front of the saw.
Replace fl ange and arbor nut, tightening arbor nut
toward the rear of the machine.
4. To remove the blade place a wood scrap in the
blade’s teeth at the front of the machine. Hold the
block of wood in such a way that if it slips or the
blade turns, your hand will not contact the blade.
Loosen arbor nut by pulling wrench toward the
front of the machine.(Fig. 22)
5. Reverse operation to remove blade.
Leveling the Blade Insert
1. Adjust table insert (A, Fig. 23) fl ush with table
by turning four leveling screws (B. Fig. 23).
2. Use a straight edge (C, Fig. 23) to make sure
the insert is fl ush with the table.
WARNING !
Figure 21
Figure 22
14
Figure 23
Assembly
A
B
C
A
B
C
Wrench