RIKON Power Tools 10-050 - Manual (Page 12)

12
Figure 14
Adjusting Fence Parallel to the Miter Slot
1. Place the fence next to the outside edge of the
right miter slot and lock it.
2. The fence should be even with the miter slot
from front to back.
3. If the fence is not even along the length of the
miter slot, unlock the fence, remove it and turn
upside down.
4. Adjust one of the two set screws (A, Fig. 14)
until the fence is even with the miter slot edge
along its entire length when locked.
Squaring Fence 90° to the Table
1. Place the fence on the saw table and lock it.
2. Place a square (A, Fig. 15) on the table next to
the fence. The fence should be 90° to the
table.
3. If adjustment is necessary, unlock the fence,
and turn one of the two nylon adjustment
screws (B, Fig. 15) until the fence is 90° to the
table.
4. Lock the fence and check the adjustment
again.
Figure 15
Fence Cursor Adjustment
1. Lock the fence down 3” from the saw blade.
2. Measure off of the blade and check if it correct
with fence scale.
3. If adjustment is needed loosen the two screws
on the cursor and align as needed. Tighten screws.
4. If further adjustment is needed loosen the
mounting bolts to the guide tube and shift it left to
right as
needed. Figure 16.
Figure 16
Assembly
A A
A
B