Seca 764 - Manual (Page 24)

24
Height measurements
– Press the START button on the dis-
play housing to switch on the device.
First appears in the height display.
The unit selected before switching off the
device is active and is marked by an
arrow.
– If required, switch the unit of height
measurement ("Toggling unit of height
measurement").
– Raise the head slide up and push the
head slide up far enough for the person
whose height is being measured to
easily stand under it.
– Ask the person being measured to
place his back against the height rod.
Make sure the person's posture is up-
right and head is straight.
– Now push the head slide down until it
rests on the person's head.
– Note down the height on the display.
Toggling unit of height measurement
Note:
This function is not available with all model variants.
The display can toggle between "cm" and "ins" (inches).
– Switch the device on. The height read-
out is displayed in the most recent unit
selected.
– To switch the unit displayed press the
cm/ins button.
– An arrow lights up next to the cm or
ins display.