SHARKOON Rush Power M - Manual (Page 8)

1x connector cable for peripheral devices
(4-pin PSU connector) for optical drives
(2 connectors) and floppy (1 connector).
1x connector cable for peripheral devices
(4-pin PSU connector) for optical drives
(3 connectors).
1x SATA connector cable
(10-pin PSU connector) for SATA drives
(6 connectors).
5. Installation
Remove an already installed PSU from the case. Proceed as follows:
1. Switch off your PC. Disconnect the PSU’s power cord from the wall outlet and your
PSU. Unplug all cables connected to the PC case (e.g. keyboard, mouse etc.).
2. Open the PC case (for additional information refer to the PC case’s manual).
3. Disconnect all cable connections between the PSU and other PC components (e.g
mainboard, HDDs, drives, fans etc.).
4. Remove the mounting screws connecting PSU and PC case and carefully take the
PSU out of the case.
5.1 Installing the Rush Power into the PC case
1. Insert the Rush Power into the PC case and put it against the PSU bracket on the
case’s back side.
2. Screw the PSU to the case from the outside using the included screws. Pay
attention not to cover the fan/air intake of the built-in PSU.
RUSH POWER M