SHARKOON USB LANPort 400 - Manual (Page 21)

USB LANPORT 100 / 400
ENGLISH
A – Left-click the link to select the respective entry.
B – To change the current password enter it into the
“Current Password” area, then enter the newly assigned
password into the “New Password” area. Confirm the
new password by re-typing it into the “Confirm New
Password” area, Left-clicking “Submit” will complete
this procedure.
7. Important notes
1. After you have successfully installed and configured the
USB LANPort (as described above) connect any USB device
to the USB plug(s) of the device.
2. You need to install the server software on every PC, from
which you want to access the USB LANPort.
3. Your operating system will treat the connected USB device
as if it was directly connected to the PC. This means that
potential drivers (e.g. printer drivers) need to be installed on
the system (for further details refer to the manuals of the
according devices).
4. As the devices will be handled like directly attached hard-
ware, we suggest to remove USB memory devices (USB
sticks, external hard disk drives etc.) using the “Safely
remove hardware” function before terminating the connec-
tion via “Disconnect”.
The server software will also prompt you with the following
note: