Source Green Heat SGH-750 - Manual (Page 3)

 Only open heater if instructed by an authorized representative of the manufacturer. There are
limited user-serviceable parts inside.
 Use heater only as described in this manual. Any other use is not recommended by the
manufacturer as it may lead to fire, electric shock, and/or series physical injury or death.
Heater Specifications
SGH Heater Model# SGH-750
Carton Size: 17.3 ” x 15.4” x 20.9” Thermostat: Electronic Analog
Heater Size: 14.9 ” L x 13” W x 17.7” H Fan System: Cross Flow Fan
Net Weight: 24.2 lbs Fan Noise Level: 46 db
Gross Weight: 27.5 lbs BTU: Approximately 5100
Cabinet: Wood, Dark Oak Delayed Start Function
Power Cord: 5.8 ft / 16 gauge Remote Control
Heating Elements: 1 Infrared Quartz Bulb “HI” Function: 1500 watts
2 Resistance wire panel system (RMS) “LOW” Function: 750 watts
Power Requirement: 120V 15 amp Washable Filter
Heating Elements Life Expectancy Potential: Rated 20,000 hrs Warranty: Limited 1-Year Parts Only
Heat Type: Quartz Infrared Heat
How It Works
The SGH Infrared Heater works with your in-home furnace to provide supplement heat. In short, room
temperature air circulates from the rear of the SGH Infrared Heater, passes through a highly efficient filter,
enters a chamber that houses the Infrared Quartz Bulbs, and exits as heated air from the Diathermanous
Copper Plate constructed on the front of the unit. The SGH Infrared Heater ideally heats a room of 500
to 700 square feet, but can be used to heat up a single room size up to 750 square feet, depending on
the ambient temperature. And it does all this with a noise level below 46db. The SGH Infrared Heater is
not for use as the primary/sole heating system.
Components and Functions
A. The SGH Infrared Heater is constructed with 1 Infrared Quartz Bulb and a 2 resistance wire
system. It functions in the following way:
B. Air is drawn inside the SGH Infrared Heater, flows along the circumference of the chamber and
over the Infrared Quartz Bulbs. The bulb and RMS system produce infrared rays that heat the air
which passes through the inner chamber.
C. A Cross-Flow Fan pushes air over these Infrared Quartz Bulbs, and is blown out laterally creating
a uniform flow of warm air.
D. The SGH Infrared Heater has a Delay Start Function which controls the AC Cross Flow Fan. The
purpose of the Delay Start Function is to allow the Infrared Quartz Bulbs to heat up before the fan
begins to circulate the air flow. In addition, the AC Cross Flow Fan will continue to circulate the
airflow after the power is turned off to circulate the remaining warm air from the Heater to cool the
unit down.
E. The LED Digital Display is a convenient, stylish, and modern way to display the set temperature
and time. This attractive addition compliments the SGH Infrared Heater, in that, it simplifies and