Source Green Heat SGH-750 - Manual (Page 6)

4) Again, the default set temperature displayed on the LED display is 72
0
F. By pressing the TEMP
button, the LED display will switch to the temperature status and flash. You must press the
HI/LOW/UP button or
0 C/ 0 F/DOWN button once again within (5) seconds to set the desired
temperature. Each time you press the HI/LOW/UP button, the temperature setting will increase
by 1
0 F. Press the 0 C/ 0 F/DOWN button and the time will decrease by 1 0 F. The maximum
temperature setting is 86 0 F (30 0 F).
5) Press the HI/LOW/UP button to switch from HI (rated at 1500W) to LOW (rated at 750W). The
default setting is HI.
6) The SGH Infrared Heater can be turned off by pressing the POWER button. DO NOT TURN OFF
THE MASTER POWER SWITCH ON THE REAR OF THE HEATER OR UNPLUG THE HEATER
UNTIL THE FAN SHUTS DOWN. If the heater is left on using the TIME function, there will be (5)
second sound alert to let you know that the time is expiring. If no actions are taken, the heater
will shut off.
7) Note that the temperature displayed on the heater may not always match the temperature
displayed on wall thermostats, thermometers, or other external temperature read-outs. This is
because the heater is often located near the floor, which allows for it to register the temperature
of the cooler air near and around the floor (warmer air rises up). It does not necessarily mean
your room is that cooler or that the heater is not hea
ting. If your heater’s display and your external
temperature read-out mechanism (thermometer, wall thermostat, etc.) are within a 5 to 6 degree
difference, it is completely normal.
Recommendations for Maximum Performance
Press TEMP to switch
to temperature status,
then press HI/LOW/UP
button once within 5
seconds to scroll up
From HI to LOW