Source Green Heat SGH-750 - Manual (Page 4)

makes controlling the unit easy. Operating the heater is logical and can be done on the unit itself
or by remote.
Unpacking the SGH Infrared Heater
1. First, check the carton to make sure there are no obvious damages that may have occurred
during shipment.
2. Open the SGH Infrared Heater packaging and remove the heater by sliding it from the box. You
may want to gently and cautiously turn the entire box upside down letting the heater slowly slide
out.
3. Remove all the protective materials from the heater. It may be a good idea to keep the protective
materials and packaging for storage during the off-season.
Operating Instructions
Visually inspect the SGH Infrared Heater for any damages before operation. Do not operate
the heater if any damages are detected. Contact your dealer immediately.
NOTE: “UP” and “DOWN” arrow buttons on the control panel and remote control have
dual function capabilities.
Adjust TIME / TEMP with up arrow or adjust HI / LOW settings.
Adjust TIME / TEMP with down arrow or adjust 0 C/ 0 F settings.
1) Plug the power cord directly into a conventional 120V 15 amp outlet and press the MASTER
POWER switch on the rear of the portable heater. Then press the POWER button on the front
control panel or on the remote to start the unit. The LED display will show the default value as
72
0 F/22 0 C.
(Note: If the ambient temperature (the temperature in the area around the heater) is greater than the set
temperature, the HI/LOW display, fan, and Quartz Bulbs will not operate.)
Function Display