Memo – Spectra Precision ProMark 700 User Guide User Manual

Page 16

Advertising
background image

English

12

Memo

[1]: Power/Fast charging pushbutton. Hold this button

depressed for about 2 seconds to power on the ProMark
700. Hold it depressed for another 2 seconds to turn it off.

While the batteries are being charged in standard mode, a
brief press on this button will cause the ProMark 700 to
switch to fast charging mode.

Whether the ProMark 700 is on or off, holding this button
depressed for 12 seconds will cause the ProMark 700 to
start a reset sequence, which lasts typically 25 seconds
(no user data lost during a reset).

[2]: Power/Charging LED. At power-up, it turns

successively and repeatedly red and green (over about 20
seconds) denoting start-up in progress. Once start-up is
complete, the LED turns solid green, unless the remaining
charge in the batteries is less than 20%, in which case the
LED will be blinking green.

When charging the batteries, the Power/Charging LED
flashes red at a slow rate (standard charging) or at a fast
rate (fast charging).

[3]: Bluetooth LED: When you turn on the ProMark 700,

the Bluetooth LED stays off throughout the start-up
sequence. Then, it produces blue flashes every 1 second
or so, until a Bluetooth connection is established between
the ProMark 700 and the data collector. The LED then
turns solid blue and will stay in that state as long as the
Bluetooth connection is kept active.

[1] [2] [3]

Advertising