Spectra Precision ProMark 700 User Guide - Manual (Page 7)

Engl
ish
3
Using ProMark 700 for the First Time
Discover Your New
Equipment
Take a few seconds to discover your ProMark 700. The power
button, LED indicators, Power/Data connector and product
labeling can be found on the bottom of the antenna.
• [1]: Power button (+fast charging control)
• [2]: Power/Charging LED
• [3]: Bluetooth LED (Wireless connection)
• [4]: 5/8” threaded insert
• [5]: 6-pin Power/Data connector with protective cap
• [6]: Shock absorber.
Charging the
Batteries
Before using your new ProMark 700, Spectra Precision
recommends you first charge its batteries in your office.
1. Unpack the AC/DC adapter. Slide the button as shown in
picture a to release the cap protecting the input contacts.
2. Of the four input connectors provided, choose the one that
matches the type of electric outlet used in your country.
Insert it as shown in picture b. You can hear a “click”
when the input connector gets fastened to the power
adapter.
3. Plug the jack end of the power cable extension to the AC/
DC adapter cable, then connect its other end to the Power/
Data connector on the ProMark 700.
4. Plug the AC/DC adapter to an electric outlet. Battery
charging starts immediately in standard charging mode.
The Power/Charging LED will first turn solid green for a
few seconds and then will blink red at a slow rate (every
3 seconds approximately).
[1] [2] [3]
[4]
[5]
[6]
a
b