Spectra Precision SP80 - Manual (Page 17)

Engl
ish
11
Using SP80 for the First Time
WARNING - This receiver uses one or two rechargeable
Lithium-ion batteries. To avoid personal injury or equipment
damage, make sure that you read and understand the safety
information at the front of this guide.
The batteries are shipped partially charged. Depending on the
time elapsed since then, the remaining charge may be even
less. For this reason, you should first recharge the batteries
completely before first use. (See warnings and safety
information at the front of this guide.)
Charging the
Batteries
1. Set up the battery charger as explained:
– Connect the output cable ([1]) of the AC/DC power
block ([2]) to the battery charger input ([3]).
– Choose the power cord ([4]) that is suitable for your
country.
– Connect the end of the power cord to the AC/DC block
input ([5]), and the other to a power outlet ([6]). This
powers up the battery charger, causing the POWER
LED to turn solid green.
2. Insert the two batteries ([7]) onto the battery charger (give
the right orientation to the battery). For each battery, the
CONTACT LED will turn solid orange when the battery is
detected. The CHARGE LED will start blinking green at a
fast rate to indicate that the battery is being charged.
3. The batteries charge one after the other. This will take a
few hours. When a battery reaches full charge, the
corresponding CHARGE LED turns solid green.
4. Remove the batteries from the charger when both fully
charged.
NOTE: The batteries may be left on the charger for an
indefinite period of time without causing any damage to
the charger or the batteries.
[1]
[2]
[3]
[4]
[5]
[6]
[7]