Spectra Precision SP80 - Manual (Page 50)

English
44
Using the Anti-
Theft Protection in
FAST Survey
• Power on the SP80. Wait until the boot sequence is over.
• On the data collector, launch FAST Survey and open a job.
• Tap Equip to access the equipment menu.
• Tap on GPS Base. Through the four tabs presented,
configure your SP80 base as desired.
• Tap to complete the base configuration.
• Still from the equipment menu, tap on the GPS Utilities
button. This opens a menu now including the Alerts Setup
button (this button is added to the menu following the
selection of the SP80 as the base receiver).
• Tap on the Alerts Setup button. Wait a few seconds until a
four-tab dialog opens through which you can define the
different parameters needed to set the remote notification
of alerts:
1. Networks tab: If “connected” is displayed in the upper
part of this tab, nothing needs to be done on this tab.
Alerts when they occur will be forwarded to their
recipients, as expected.
If “Disconnected” is displayed, you need choose the
communication device (WiFi or GSM) over which
notification emails or/and SMS will be sent to the
registered recipients. Typically, you need to make this
setting when a radio data link is used to route RTK
corrections.
2. Email tab: Allows you to enter up to 5 different email
addresses that will receive warning emails, should
alerts be set.
The check box placed before each email address entry
allows you to include or reject the email address from
the email distribution list. You can for example reject
an email address but keep it in memory for future use.
Alert Level scroll-down list: Allows you to choose which
alerts should be notified to the remote operator
through emails. See table below.
Receive Theft Alerts check box: Tell FAST Survey
whether or not theft alerts, when triggered, should be
forwarded via email to the registered recipients (check
the box if this is what you want, otherwise clear it).
Alert Level Field
Setting
Notifications
None None
Standard Only for level-1 alerts, except for theft alert
Full For level-1 and level-2 alerts, except for theft alert