Spectra Precision Survey Pro v3.80 Ranger GPS User Manual - Manual (Page 85)

Trouble Shooting
81
•
Tap 6(7 to configure the base station. Since the Localization
adjustment is already solved, you will not be prompted to
solve the projection again.
10. Check points and add control point.
•
Go to Control Points. Select point 2 and tap &KHFN 3RLQW.
Since you have not yet set the rover, tap 6HW 5RYHU 1RZ at the
prompt, then retap &KHFN 3RLQW. The results should be
perfect.
•
Add Control Point 2 . Deselect the H / V check when you are
collecting it. This point will be used only if necessary.
11. Move the base to a point in the coordinate file not measured with
GPS.
•
Go to Base Setup, select point 4 and tap 1H[W!. Since this
point does not have geodetic coordinates, you are prompted to
compute coordinates from the known (N,E,Elev) and the
latest projection solution. Tap
2.
Note: This action is equivalent to the TDS “Move Base” routine in the
DOS software.
•
The geodetic coordinates for point 4 are computed. Tap
6(7
to configure the receiver.
12. Set the Rover.
13. Check points.
•
Go to Control Points. Select point 2 and tap Check Point.
The results should be perfect.