Spectra Precision Survey Pro v3.80 Ranger GPS User Manual - Manual (Page 93)

Trouble Shooting
89
Trouble Shooting
Hardware Configuration
o You attempt to auto detect and the program fails to find the baud
rate of the receiver.
¾ Check to make sure you selected the correct brand and
model.
¾ The port you are connected to may be ‘broken’ or
temporarily unavailable. Plug into another port and try
again.
¾ If you cannot detect the baud from any of the ports, toggle
the power on the receiver and try again.
¾ If you still cannot connect, do a soft reset of your receiver
hardware.
¾ If you still cannot connect, do a hard reset of your receiver
hardware.
o You attempt to auto detect baud rate and port and it takes
several seconds to check each baud rate.
¾ You are plugged into a port that is sending out other
traffic, this receiver is probably in base mode and is
sending RTK corrections out the port you are connected
to.
¾
Plug into a different port and try again.
o You attempt to change or check the radio channel and the radio
does not go into command mode after you toggle the power
¾
Older versions of the radio firmware do not behave well at
faster bauds. Set the data collector to receiver baud rate
to 9600 and try again.
¾
If this still does not work, try leaving the radio unplugged
for five seconds before plugging it back in.