Autostart CT-5060 - Manual (Page 10)

CT-5060 User Guide P. 10
3
• Entering Cold Weather Mode
• Exit Ready Mode
• Enter Remote Valet
• Enter ignition valet
4
• +12 volts detected on the Brake line; cranking cancelled
• Entering Tach Learning
5
• New Transmitter learnt
• Tach learnt
6
• Remote start attempt was made with a Tach or a vacuum signal
detected before cranking
8 • Unit reset: occurs when the unit is reset to factory defaults
10 • The Hood Switch line went to ground during cranking or run time
1 – pause
– 2
• There was an attempt to start the vehicle while the Module was in
Valet Mode.
2 – pause
– 2
• There was an attempt to start the vehicle while the Module was in
Home Valet Mode.
ON solid • Cold Weather Mode: the Brake Pedal is being held down
ON 2 sec.
• The Hood is up and the Hood Switch line went to ground. This is
step one of the Programming Mode
ON 3 sec.
• First press of the
START/STOP
button under Safe Start.
• Entering Home Valet Mode
ON 4 sec. •
LOCK
or
UNLOCK
pulse (if door pulse is configured to 4 sec.)
ON
25 sec.
• If the Hood Pin-switch has been pressed twice: the Unit went into
step 1 of the Programming cycle and no Transmitter activity was
detected for 20 seconds
• Or the Unit went into step 1 of the Transmitter Code Learning
procedure and no activity was detected for a few seconds. The
Unit has exited the Transmitter Code Learning procedure.
Irregular
• If the Module gives irregular flashes (1 to 10 flashes followed by a
pause, followed by more flashes), it is in Playback Mode. This
occurs when the Hood-switch line is flashed 3 times.
Constant
flashes
up to
30 sec.
• Panic Mode set off.