Star Water Systems EL10S - Manual (Page 12)

12
PUMP ELECTRICAL CONNECTIONS (CONTINUED)
3. Insert an electrical wire strain relief into the
opening in the side of the pressure switch
closest to the motor. ( Fig. 3)
IL1372
3
IL1373
Wire from
motor
4
IL1374
Wire from
motor
5
IL1375
Wire from
motor
Ground Screws
6
6. Connect the green ground wire from the
motor cable to one of the green ground
screws at the bottom of the pressure switch.
( Fig. 6)
5. Connect the two motor wires of the motor
cable to the two inside terminals on the
pressure switch. ( Fig. 5)
4. Thread the cable from the pump motor
through the strain relief into the pressure
switch cavity and tighten both screws on the
strain relief. Do not crush wire. ( Fig. 4)