AEG KO-LAVAMAT 72620 - Manual (Page 17)

Operating instructions
17
Performing A Washing Cycle
Brief Instructions
A washing cycle is performed in the following steps:
0 1. Set the correct washing program:
– select the program and the temperature with the program selector
– select additional program(s) if required
2. If required, change the spin speed/select RINSE HOLD.
3. Set the
]
(DELAY TIMER) if necessary.
4. Open the door, load the washing.
5. Close the door.
6. Add detergent/conditioner.
7. Start the washing program.
At the end of the washing program:
Important! If the washing cycle ends with a rinse hold, perform either
C (PUMP OUT), D (SPIN) or F (SHORT SPIN) before opening the door.
8. Open the door, remove the washing.
9. Switch off the washing machine: set the program selector to I (OFF).