AEG KO-LAVAMAT 72620 - Manual (Page 23)

Operating instructions
23
Washing Cycle Complete/Removing the Washing
Once the washing program has come to an end, L (END) illuminates
on the program progress display.
If o (RINSE HOLD) was selected, the indicator beside the O/s
(START/PAUSE) button flashes.
0 1. After a RINSE HOLD, the water must first be pumped out:
– Press either the O/s (START/PAUSE) button (the washing will be
spun in accordance with the program which has just been completed;
the spin speed can also be changed during spinning using the spin
speed/o (RINSE HOLD) button),
or
– turn the program selector to C (PUMP OUT), and press the O/s
(START/PAUSE) button (the water is pumped out without spinning),
or
– turn the program selector to D (SPIN) or F (SHORT SPIN), and press
the O/s (START/PAUSE) button (the washing will be spun or short
spun).
At the end of this program step, the END indicator will illuminate.
2. Open the door.
As soon as the K (DOOR) indicator is green, the door can be opened.
3. Turn the program selector to I (OFF).
4. Remove the washing.
5. Close the water tap.
6. Pull the detergent drawer out a little after washing so that it can dry
out. Leave the door ajar so that air can circulate in the washing
machine.
3 If the Å (OVERDOSING) indicator illuminates, then too much deter-
gent was used in the washing program just completed, and as a result
an additional rinse performed. Next time you use the machine, observe
the detergent manufacturer’s dosing instructions for the load to be
washed!
Important! If the washing machine is not to be used for a long period:
close the tap and isolate the washing machine from the mains.