Triangle Engineering of Arkansas AQ3613 - Manual (Page 2)

ATTEMPTING TO INSTALL, OPERATE OR SERVICE THIS FAN. FAILURE
TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL
INJURY AND/OR PROPERTY DAMAGE. RETAIN INSTRUCTIONS FOR
FUTURE REFERENCE.
WARNING:
There is a risk of fire, electric shock, or injury to persons.
GENERAL SAFETY INFORMATION
1. Your AQUACOOL fan will operate only on 115 Volt AC, 60Hz (cycle) current with a
minimum of a 15 Amp circuit.
2. WARNING: To guard against electric shock while the fan is connected to power
source, DO NOT PERMIT fan to come in contact with other grounded objects such
as pipes, radiators, ranges
3. DO NOT ABUSE POWER CORD. DO NOT pull on cord to remove from electrical
receptacle. Keep cord away from heat, oil and sharp edges. Inspect cord periodically
and replace if damaged.
4. Disconnect the fan when not in use, before servicing and cleaning and when
repairing or replacing parts.
5. DO NOT move the fan when connected to power source. Be sure switch is in
“OFF” position prior to connecting to power source.
6. Use of this fan with an extension cord is not recommended. If the AQUACOOL
is used with an extension cord, use only cord of proper size (Amp rating), UL listed
and with receptacle to accept three prong grounded plug furnished on the fans
power cord. Only round jacketed extension cords should be used.
7. Before operating this fan, check for worn or damaged parts and replace or repair
as required. To avoid risk of fire, electrical shock or other injury, disconnect from
power source before servicing.
8. DO NOT operate the AQUACOOL near flammable liquids or in gaseous or
explosive atmospheres as sparks from motor may ignite fumes.
9. If the pads or wire guards are removed, replace before operation.
10. In case of power failure, turn off the fan at switch. This will prevent motor burn out
and/or unexpected restarting.