Triangle Engineering of Arkansas AQ3613 - Manual (Page 3)

Assembly instructions
1. Remove pallet straps.
2. Remove metal guard located above evaporative cooling pads.
3. Remove center cooling pad by gently pulling pad out- ward. Additional pads
may be removed to allow more access to inside of fan.
4. Check pump for upright position.
5. Check spray bar and splash guard for proper alignment. (see Manual)
6. Replace cooling pads, inserting center pad last.
7 . Attach metal guard over cooling pads and tighten screws.
8. Attach water hose to unit and turn on water supply.
9. Turn on pump to begin water flow.
10. Turn on fan to begin enjoying your AQUACOOL evaporative cooler!
Note: Minerals found in some water supplies may cause bubbles to form. If you experience a
bubbling problem after unit is in operation, flush unit of all water and refill reservoir. Cooling pads
should become accustomed to these minerals and cease to bubble. If problem continues or is
excessive, add a bio-guard anti-foaming agent to reservoir, which is available at most swimming pool
supply stores.
DO NOT USE DETERGENT IN UNIT!