Work Sharp WSKTS-KO KNIFE & TOOL SHARPENER User Guide User Manual
Page 7
7
Motor
Be sure your power supply agrees with nameplate marking. 110 Volts AC
only means your tool will operate on standard 60 Hz household power. Do not
operate AC tools on DC. A rating of 110 volts AC/DC means that your tool
will operate on standard 60 Hz AC or DC power. This information is printed on
the nameplate. Lower voltage will cause loss of power and can result in over-
heating.
Extension Cords
When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. The following table shows
the correct size to use depending on cord length and nameplate ampere rating. If
in doubt, use the next heavier gage. The smaller the gage number, the heavier the
cord.
SAVE THESE INSTRUCTIONS
Minimum Gauge for Cord Sets
Volt
Total Length of Cord in Feet
120V
0 - 25
(0-7.6 m)
26 - 50
(7.6-15.2 m)
51 - 100
(15.2-30.4 m)
101 - 150
(30.4-45.7 m)
230V
0 - 50
(0-15.2 m)
51-100
(15.2-30.4 m)
101-200
(30.4-60.9 m)
201-300
(60.9-91.4 m)
Ampere Rating
American Wire Gauge
More Than
Not More
Than
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Recommended
Intended Uses:
• Grinding, Sharpening and Honing applications on knives and tools.
• Light duty grinding in metal.
• Only for use with consumer applications.
• Tool should only be used with sharpening cassette installed.
Unintended Uses:
• Industrial or commercial grinding or sharpening applications.
• Extended, continuous heavy duty use.