Aposonic A-H2A8D2 - Manual (Page 79)

- 79 -
item.
UPNP Port Forwarding – to use UPnP port forwarding for Control/Data/HTTP
port for internet access if the router supports UPnP. Press
+/- buttons to change
the value. If UPnP port forwarding is used, the DVR will try to connect with
UPnP router to set Control/Data/HTTP port after the user exits from this screen.
It may take from a few seconds to a few minutes. If successful, new
Control/Data/HTTP port will be shown with (*) in front of it.
WAP Picture Quality – the WAP picture quality if WAP access is supported for
the DVR. Press
+/- buttons to change the value.
Video Stream Resolution – network live video stream resolution. Press +/-
buttons to change the value.
Video Stream Quality – network live video stream quality. Press +/- buttons to
change the value. Please note that the value cannot be changed due to the
limitation of the main chip.
DVR Name – the “DVR Name” used in the “CMS Server” if CMS Server
(described below) is (to be) connected with the DVR. Please follow the Text
Input method described in Section 4.1 to modify this item.
CMS Server URL #1-2 – the URL (Uniform Resource Locators) for the CMS
Server #1 and #2. The DVR will connect with up to two CMS servers
automatically once it’s running. Please note that with this feature, the DVR
needs not to be a web server, while the CMS server needs to be a web server.
Please follow the Text Input method described in Section 4.1 to modify these
items.
IP Filter #1-4 – the IP filters #1-4 for remote access. Only those PCs with IP
addresses matching one of the IP filters can access the DVR remotely. Please
follow the Text Input method described in Section 4.1 to modify these items.
Note: If the Control Port or Data Port is not available or accessible during
remote access, the system will reset the ports to their default values, i.e.
67/68.