AW Gear Meters LLC-BA - Manual (Page 26)

LLC-BA Batch Unit
Operation and Programming Manual
25
Decimal Point for KFT
This variable selects the location of the decimal point in the KFR factor and the display. This display is
always zeros with a decimal point.
0000000. (factory default)
Use the UP or DN key to move the decimal point left or right. Press ENT to store and advance to the next
variable.
Engineering Units KFT
Enter the engineering units for display of rate with up to three characters or letters. Example: Gal
pul (factory default [pulses])
Program or edit the left-most character first. Press UP or DN until it appears. Then press SEL to store.
Repeat the procedure for the second character. Repeat for the 3rd character but store with the ENT key.
The LLC-BA will exit to the Display Mode.
This ends the variable programming procedure. The LLC-BA will display the currently selected mode. To
initiate batch operation, the PROGRAM/RUN input must be closed (TERM 4 connected to TERM 2) to
enter the RUN mode.
Batch Programming
The LLC-BA must be in PROGRAM mode to program batch quantities. Nine different batches (1-9) can be
programmed. You must enter program variables before the batch programming. Batch quantities are
based on the programmed KFT value, KFT engineering units and decimal point.
The maximum value you can enter for a batch is 429496 regardless of decimal place. Values greater
than 429496 are not accepted. The more decimal places in the KFT, the smaller the batch that can be
programmed. To program larger batches it may be necessary to reduce the number of decimal places in
the KFT.
Example:
KFT = 214.38 and the desired batch is 6000.00. Ignoring decimal location, the value of 600000 is greater
than 429496 and will not be accepted. The solution is to reduce the decimal places of the programmed
KFT. With KFT changed to 214.4, batch is 6000.0. Ignoring decimal location, the value of 60000 is now
less than 429496 and will be accepted.