Axxess Interface ASWC - Manual (Page 12)

12
5) Now press and hold the “Volume Down” button until the LED
goes solid red. Release the button and the LED will turn “off”. The
“Volume Down” has now been programmed.
6) At this point go to the ASWC Legend Button Assignment
(remapping/manual programming) section, page 19, and continue
with “Seek Up/Next” button.
7) You can end this half of the programming in 2 ways:
(1) After the last button on your steering wheel has been
programmed (you do not have to go through the whole list) hold
down the “Volume Up” button for at least
10 seconds. The LED will go into a slow constant blink mode.
--- Or ---
(2) After the 18th button is programmed or skipped the LED will go
back to the slow constant blink mode.
Note: If at any time an error is made hold down the reset button
on the ASWC for 10 or more seconds. This will restart the
manual programming. Go back to Step 4 and start again.
8) Press and hold the “Volume Down” button for 5 seconds till the LED
starts to flash quickly.
9) Release the “Volume Down” button.
10) After 4 seconds of the LED flashing quickly the LED will go out
for 2 seconds.
Section 3: Troubleshooting