Axxess Interface ASWC - Manual (Page 7)

7
Section 1: Installation
4) If you are using an Eclipse, Kenwood, Metra OE, or a newer JVC
radio, plug the included female 3.5 mm connector with the Brown
and Brown/White wires into the male 3.5 mm connector of the
ASWC harness.
• For Kenwood and select JVC: Connect the SWC wire (normally
Blue/Yellow) to the Brown wire of the ASWC. Isolate and tape
the
Brown/White wire, it will not be used.
Note: Some newer Kenwood radios will auto detect as a JVC. If
this is the case, you can use a 12k-ohm resistor (included) in line
between the
Blue/Yellow and Brown wire of the female 3.5 mm
jack during programming only. Or you can manually set the radio
type which is in the radio programming section of this manual.
• For Eclipse: Connect the Eclipse SWC wires (normally Brown
and
Brown/Black) to the Brown and Brown/White wires of the
ASWC. Brown goes to Brown and Brown/White goes to Brown/
Black. Sometimes this is reversed, reverse the wires if needed.
• For Metra OE: Connect the SWC Key 1 wire (Gray) to the Brown
wire of the ASWC.
5) For all other radios, plug in the male 3.5 mm connector of the ASWC
into the back of the aftermarket radio, designated for an external
SWC control interface. If in doubt where the 3.5 mm connector of
the ASWC goes please refer to the aftermarket radio manual. Once
all connections have been made, plug in the aftermarket radio if not
done already.