Edwards Signaling 5541M-Y6 - Manual (Page 7)

P/N 3100471 ISSUE 3 PAGE 7
Chapter 2 - Installation
2.1 - Installation checklist
‰ Prepare the site. Make sure the installation location is free
from construction dust and debris and extreme temperature
ranges and humidity.
‰ Unpack the equipment.
‰ Install the cabinet. See "Installing the Cabinet" for dimensions.
‰ Plan wire routing. See Appendix D or the panel label.
WARNING
Prior to making any electrical connections, ensure
power is disconnected.
‰ Connect the field wiring. See Appendix D or the panel label.
Meter for opens, grounds, and shorts before connecting.
‰ Connect AC power and ground. See Figure 4 and Appendix D
or the panel label.
‰ Connect Standby power. See Figure 5 and Appendix D or the
panel label. NOTE: When the System Master is used with a fire
alarm panel, Standby Power MUST be installed and enabled.
‰ Program the panel. Refer to Chapter 3.
‰ Verify operation.
1. Initiate contacts--listen for tones
2. Push initiation buttons - listen for tones
3. Break audio & power leads to test supervision. Panel
should go into trouble.
4. Adjust audio levels.
5. Check program switch is locked, deadfront is installed
and door is locked.
2.2 - Installing the cabinet
Cabinets can be surface mounted or semi-flush mounted. See Fig-
ure 2 for framing and mounting dimensions.
2.2.1 - Surface Mounting
1. Position the cabinet on the finished wall surface.
2. Fasten the cabinet to the wall surface where indicated in
Figure 2 using (4) 1/4" x 2" lag screws for wood, (4) 1/4" x 1"
sheetmetal screws for steel, or (4) 1/4" x 2 1/4" wedge anchors
for cement.
2.3 - Installing Power
Figure 2. Panel Dimensions
1. Review specifications Appendix C for power requirements.
Provide branch circuit wiring rated for panel requirements.
2. Connect green ground wire to terminal "G" on terminal block
TB5 (Figures 3 and 4).
3. Connect incoming Neutral to terminal "N" on terminal block
TB5. Connect incoming Hot to terminal "L" on terminal block
TB5 (Figures 3 and 4).
DANGER
High voltage present when power applied. Prior to
making any electrical connections, ensure power is
disconnected.
11.56" 3.39"
18.00"
14.00"
10.06"
1.22"
NOTE: System Master Shown without Doors Installed