GW Instek GOS-652G - Manual (Page 32)

⎯ 27 ⎯
CH2 Displayed
Set values of CH2 signal are displayed at (2) when the VERT MODE is at CH2,
DUAL or ADD. They are not displayed in the CH1 mode.
(a)……“P10 ” sign is shown when the probe ×10 is setted.
(b)……“> ” sign is shown when the V/DIV is at UNCAL position.
(c)…… Display the selected sensitivity from 1mV to 5V. (Probe x10 from 10mV to 50V)
(d)……“y ” sign is shown at X-Y mode.“y2 ” sign is shown at DUAL X-Y mode.
ADD(SUB) & CH2 INV Display
The ADD, SUB and INV functions are displayed at (3).
(a)……“+ ” is shown when the VERT MODE is at ADD position, then the inputs
CH1 & CH2 are algebraically summed.
(b)…… A “
↓ ” sign is displayed when the VERT MODE is at CH2 or DUAL
and the CH2 INV button is engaged. When the CH2 INV button is
pushed in, the subtraction of CH2 from CH1 is in function.
TIME Display
The sweep time is displayed at (4). The A sweep time is shown at the under row, the B sweep time is shown at the upper row(B sweep
for 658G only)
(a)……“A ” and “B ” are shown at A and B sweep time.
(b)……“ = ” is shown normally. “ * ” sign is displayed when the x10 MAG button is pushed in. “ > ” sign is displayed when the
SWP. UNCAL button is engaged.
(c)…… shows the selected sweep time from 10ns to 0.5s. An “X-Y ” is displayed when the X-Y button is pushed in.
CHOP / ALT Display
T
he “CHOP ” or “ALT ” are displayed at (5) when the VERT MODE is set to DUAL. When X-Y button is engaged, an “XEXT ” is
displayed.
TV-V / TV-H Display
The “TV-V ” or “TV-H ” are displayed at (6) when the TRIG. COUPLING is set to TV position.
(6)
(5) (4) (2) (3) (1)
(a) (b) (c) (d) (a)(b) (a)(b) (d) (c)
(a)(b) (c)
0%
10
90
100
(a) (b) (c)
(7)
Figure 4-16