GW Instek GOS-652G - Manual (Page 33)

⎯ 28 ⎯
Cursor Measured Value Display
The relative measured values of the seven functions are displayed at (7).
(a) … …Shows each of seven functions ( △V, △V%, △VdB, △T, 1/△T, DUTY, PHASE ) which may be selected by the CURSOR
FUNCTION button. The △ V function provide different △ V ( △ V1, △ V2, △ V12, △ Vy, △ Vy1 )
according to the following table：
VERT. MODE
CH1 CH2 DUAL ADD
CH1
△V1
CH2
LINE
TRIG.
SOURCE
EXT
△V1 △V2
△V2
△V12
X-Y *1
△ Vy △Vy1
*1
NOTE： *1：When X-Y mode is not set at correct position, the error message
“X-Y mode error ”is shown.
(b)……In the △V function, a “ + ” or “ - ” polarity is shown. “+ ”when the ▽(delta) cursor is above the ▼ (REF.) cursor; “- ”when
the ▽(delta) cursor is below the ▼ (REF.) cursor.