HT instruments HT32 - Manual (Page 4)

HT32
EN - 3
 Before connecting the test probes to the installation, make sure that the function
selector is positioned on the required measurement.
 Make sure that LCD and function selector indicate the same function.
1.2. DURING USE
Read the recommendations which follow and the instructions in this manual:
CAUTION
An improper use may damage the instrument and/or its components or
injure the operator.
 When changing the range, first disconnect the test leads from the circuit under test in
order to avoid any accident.
 When the instrument is connected to measuring circuits never touch any unused
terminal.
 When measuring resistors do not add any voltage. Although there is a protection
circuit, excessive voltage could cause malfunctioning.
 If during measurement the displayed values remain constant check whether the HOLD
function is active.
1.3. AFTER USE
 After using the instrument turn it off.
 If you expect not to use the instrument for a long period remove the battery to avoid
leakages of battery liquids which may damage its inner components.