In-Situ Aqua TROLL 100 and 200 Operators Manual - Manual (Page 60)

Page 60 Aqua TROLL Operator’s Manual
Configuring Depth and Level
This procedure stores the configuration settings in the Aqua
TROLL Instrument. When setting up a log, the same options are
presented.
1. While connected to the instrument in software, click the
Sensors tab.
2. Select the sensor and click the Configure button .
TIP: When you
configure level
using the Sensors
tab, the settings are stored in
the Aqua TROLL Instrument
and are available for use in
Modbus, SDI-12, and analog
communications, as well
as in Win-Situ. Different
configurations may be selected
when setting up a log.
Sensors tab
Configure button
Select the sensor
TIP: Go to the
Home tab and
stop polling
before configuring any sensor
parameter.
Section 6: Pressure & Level