In-Situ Con TROLL PRO Installation Manual (purchased after 10 May 2012) - Manual (Page 20)

20
Input/Output Connections
The Input/Output board is shown in Figure 5.1 . It is located inside the enclosure on the
left side. Refer to the individual probe manuals for wiring diagrams. Also refer to the
Con TROLL PRO Operator’s Manual.
Figure 5.1 Input/Output board and required wire types
Do not over tighten the screws on the terminal block.
PLC Connections
Danger—Make sure that power to the instrument is disconnected before making
any wiring connections.
Connexions Pour Automate Programmable Industriel
Danger—Débrancher toute alimentation à l'appareil avant de connecter les fils.
PLC connections typically consist of the following items.
l
AC model: 24 VDC output to power accessories
l
DC model: 9-36 VDC inputs to power the controller (required)
Danger—Do not connect AC power to DC powered model!
Danger—Ne pas connecter la version courant continu de l'appareil au secteur (au
courant alternatif)!