In-Situ Con TROLL PRO Installation Manual (purchased before 10 May 2012) - Manual (Page 20)

20 Electrical Connections
FIGURE 19. AC circuit board and terminal connections
1. Disconnect power to the instrument.
2. Use a Phillips screwdriver to remove the controller lid.
3. Use a Phillips screwdriver to remove the AC board cover.
4. Carefully pull the cover out of the enclosure.
5. Connect the green Protective Earth wire to the metal screw as shown in
Figure 18.
6. Connect the opposite end of the Protective Earth wire to the circuit board as
described in Table 1.
7. Connect the stripped and tinned black and white conduit or power cord wires to
the terminal strip as described in Table 1 and Figure 19.
8. Place the cover back in the enclosure and retighten the screw.
9. Replace the controller lid.
10.Reconnect power to the device.
P
O
W
E
R
R
E
L
A
Y
1
R
E
L
A
Y
2
N
L
NO2
COM
NC2
J1
J2
J3
F1
C4
RV
1
RT1
L1
C2 C3
C1
U1
K1
K2
D1
K1
D2
C3
J4
1 2
IN-SITU INC 0081676
NO1
COM
NC1