In-Situ Con TROLL PRO Installation Manual (purchased before 10 May 2012) - Manual (Page 29)

Maintenance 29
Chapter 7 Maintenance
Danger
Only properly trained and qualified personnel should
install the Con TROLL instrument described in this manual.
This instrument should be installed for use in non-
hazardous locations only.
Danger
Installation de l'appareil “Con TROLL” décrit dans le guide
d'utilisateur doit impérativement se faire par des
personnes qualifiées. L'installation de cet appareil est
seulement prescrite pour des emplacements sans risques.
7.1 CLEANING THE OUTSIDE OF THE ENCLOSURE
Wipe the enclosure periodically with a damp, soft cloth. Do not use solvents.
7.2 REPLACEMENT DESICCANT
Desiccant ensures the longevity of the electronic components inside the
enclosure. Replace the desiccant (Cat. No. 0087630) when it turns from blue
to pink.
Danger
Make sure that power to the instrument is disconnected
before making any wiring connections.
Danger
Débrancher toute alimentation à l'appareil avant de
connecter les fils.
1. Disconnect AC power to the instrument.
2. Use a Phillips screwdriver to remove the controller lid.
3. Replace the pink desiccant with new a desiccant pack.
4. Replace the controller lid and tighten screws.
5. Reconnect power to the device.
7.3 REPLACEMENT C-CELL BATTERIES
Danger
Do not use lithium or rechargable C-cell batteries. Use only
alkaline C-cell batteries.
Danger
Ne pas utiliser de piles au lithium ni de piles
rechargeables. Utiliser uniquement des piles alcalines de
type “C”.