In-Situ Con TROLL PRO Operators Manual (purchased before 10 May 2012) - Manual (Page 5)

Getting Started 5
Chapter 1 Getting Started
1.1 SENSOR INSTALLATION REQUIREMENTS
Before making any wiring connections between the probes and the module, make
sure that the probes are set to their factory-default communication settings! If you
are using brand new probes, you do not need to do anything. If you are using pre-
existing probes, use Win-Situ software to reset the default communication settings.
1. Open Win-Situ software and connect to the probe.
2. Change communication settings for the device by selecting Preferences, then
Comm Settings. Click the Reset All Devices button.
This returns the device communication settings to their serial communication
defaults (19200, 8, Even, 1, RTU, and Device Address 1).
1.2 NAVIGATING THROUGH THE MENUS
After your Con TROLL PRO module has been completely installed by a qualified
professional, according to the Installation Manual, you can begin operating the
keypad. If you have an AC-powered model, the display will initially be “on”. If you
have a DC model, push any key to turn on the screen.
Figure 1 shows the keypad and display window.
FIGURE 1. Keypad and display window
1.3 INITIAL CONFIGURATION
Enter the following information upon first use or anytime after you have restored the
default settings.
1. You will first be asked to select a language. English, Spanish, and French are
available. Use the arrow keys to move up or down to the appropriate language.
Select Enter to accept the language.
2. Use the arrow keys to adjust the Contrast level. Select Enter to accept the
contrast.
Command Command
Left function key Right function key
Up/Left arrow key
Down/Right arrow key