Jenway Genova Nano German - Manual (Page 91)

Squeeze the grey plastic clips together so that the printer
top opens. Slot the printer into the top of the instrument
and push down until it fits flush to all four sides.
Insert the paper roll into the printer – ensuring that there
is some paper sticking out of the printer before clicking
the grey plastic back into place. Switch the instrument on.
The power and error lights on the printer will flash. Once
the instrument power on tests are complete press the feed
button to check that the paper is fed correctly.
18.2.2 Passive Accessories
Unscrew the thumb screw to undo the passive accessory. Lift
out the passive accessory. To fit a different passive accessory
simply place the accessory in the correct orientation, align
the thumb screw and tighten to fix in place.
To replace the passive accessory with an active accessory
refer to section 18.2.3.
18.2.3 Active Accessories
Unscrew the thumb screw to undo the passive accessory.
Lift out the passive accessory. To fit an active accessory
unscrew screws 1 to 4 and lift out the metal base plate.
Thumb screw
89