KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.3.05 to 4.07 - Manual (Page 30)

1-10
BOP HIPWR 031912
MISCELLANEOUS FEATURES (Continued)
Power-up Settings Mode Voltage (default) or Current
Main Channel
Reference Type
Internal (default), External or External
Reference Level (Gain Mode)
Protection Limit Channel
Reference type
Internal (default), External
or Lesser Limit
Applies to Limit channel
Protection Limit
Levels
(Internal)
EO
MIN
or IO
MIN
to
1.01 EO
NOM
or IO
NOM
Voltage (Volts) for Current mode,
Current (Amperes) for Voltage mode
Output status On (default) or Off
Password
Types
Main, Admin1, Admin2
Factory defaults: Main: DEFAULT,
Admin1: none assigned, Admin2: KEPCO
Protection Choices Unprotected, Main, Admin1, Admin2 Password menu always protected by Admin2
Items Protected Interface, max/min , Load type, Test,
Calibration, Power-up, Keypad @
local, Keypad lockout at power-up,
Save Display Chg
(See Figure 3-5 for defaults)
Multiple unit configurations are protected by
Admin2 password.
Save Display Chg choice is Enable or Dis-
able; when set to Disable, prevents changes
made to the display settings from being saved
for power up.
Series, Parallel, Series x Parallel configura-
tions of identical units Single, Parallel, Series, 2 X 2, 3 X 2 2 X 2 is two parallel branches of two series-
connected identical units.
3 X 2 is two parallel branches of three series-
connected identical units.
GENERAL (ENVIRONMENTAL) CHARACTERISTICS
Temperature operating 0 to +50 deg C Full rated load
storage -20 to +85 deg C
Cooling Two internal fans exhaust to the rear
Humidity 0 to 95% RH non-condensing
Shock 20g. 11mS ±50% half sine non-operating
Vibration 5-10HZ: 10mm double amplitude 3 axes, non-operating
10-55HZ: 2g 3 axes, non-operating
Altitude sea level to 10,000 feet
Safety Certification a-c power UL 3101-1 and EN 6101-1 Pending
TABLE 1-2. BOP GENERAL SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION