KROHNE OPTIWAVE 7300C Quickstart EN - Manual (Page 19)

INSTALLATION
2
19
OPTIWAVE 7300 C
www.krohne.com 03/2014 - 4000050005 - QS OPTIWAVE 7300 R08 en
2.9.5 How to turn or remove the signal converter
INFORMATION!
The converter turns 360
° . The converter can be removed from the process connection assembly
under process conditions.
Figure 2-23: How to turn or remove the signal converter
1 Tool: 5 mm Allen wrench (not supplied)
2 Cover for the wave guide hole on top of the process connection assembly (not supplied)
CAUTION!
If you remove the converter, put a cover on the wave guide hole on top of the process connection
assembly.
When the converter is attached to the process connection assembly, tighten the lock screw.