Agilent Technologies 82357B - Manual (Page 11)

82357B USB/GPIB Interface
3 Connecting the 82357B
82357B Quick Start Guide 5
3 Connecting the 82357B
Plug the 82357B into a USB Port
Plug the 82357B USB cable into an available USB port on your
PC or on a supported USB hub. To connect to USB hubs, see
the 82357B User's Guide. The picture shown below is for
illustration purposes only. It is not necessary to connect the
82357B to any GPIB instruments at this time.
Observe the 82357B LEDs
Observe the three LEDs on the 82357B. Initially, only the red
FAIL LED should be illuminated. After 10 seconds, all three
LEDs should be illuminated to show that the 82357B has been
installed, and is configured for use with the IO Libraries.
USB Cable
READY LED
FAIL LED
ACCESS LED
82357B
N O T E
If any LED is not illuminated after 10 seconds, see Chapter 3,
“Troubleshooting the Agilent 82357B” in the 82357B User's
Guide for more information.