KYORITSU 4106 - Manual (Page 38)

34
10. Store/ Recall the Measurement Results
Measurement conditions and measured results can be saved in the memory
of the instrument. (max 800)
The stored data can be transferred to a PC via an Optical Adaptor
Model8212USB by using a special software “KEW Report”.
10-1 How to save the data
Press the “
” Key when an earth resistance measurement is finished.
Then the LCD reads as shown in Fig.45.
Press the “ ” Key again, and then “saved” is displayed with highlighted
at the lower right of the LCD and the measured values are saved. (Fig.46)
Press the “ ” Key to return to the Main Screen.
Note) Pressing the TEST Button again initiates another measurement.
Note) Data cannot be saved while the Low Battery Mark is displayed on
the LCD.
Note) When the saved data reaches to the max limit of the capacity (800),
“Full” is displayed at the upper left on the LCD as shown in Fig.47
and no more data can be saved.
When trying to save data with memory capacity is full, a message shown in
Fig.48 is displayed. Press the “
” Key and return to the Main Screen.
To save new data, it is necessary to delete the old data first. See “10-3
How to delete the saved data” to delete the saved data in the memory.
Fig. 45
Fig. 46
Fig. 47
Fig. 48