SHIMPO TNP-Series - Manual (Page 15)

14
XI. Zero adjustment / Tare the TNP
Taring or zeroing the value of the TNP initialize the torque meter to zero.
This function is performed by pressing Zero/RST button on the front panel. In
OPEN and CLOSE modes this zeros out the Peak values measured.
It is essential that the TNP be zeroed out before performing another
test. This ensures that the TNP is properly initialized and no
additional values are added to the measurement.
XII. Saving Data in Memory
Data can be stored in the TNP meter by pressing the Mem key. This feature is
only available in OPEN and CLOSE measuring modes.
NOTE: In MEAN or Average mode the Mem key has no function.
When the number of data points > 1000
001
Memory registration
After 1 sec, digits will return to original display.
After 1sec, the peak value displayed will
automatically reset to zero; ready for
another test.
Nm Nm
Nm
“Open”or“Close”
measuring mode
Mem
001
Taking a closer look at display the upper sub-display indicates the
memory identification or data number.
Memory identification/Number