Calibrating level 41, Calibration (cal) 41, Calibrating level – West Control Solutions TB 45 Temperature Limiter User Manual
Page 41
.
9
Calibrating level
In the calibration menu (
CAL) the measured value can be adjusted.
a
Please, note that the input value may be shifted when handling the calibration function. Therefore, check
the effects on the adjusted limit value.
g
The measured value correction (
CAL) is accessible only, if ConF / InP/ Corr = 1 or 2 was
selected.
Two methods are available
•
Offset - correction
•
2-point - correction
g
The
InL.x and InH.x values are presented with one digit. As reference for the correcting calculation the
full resolution is used.
g
Deleting the correction values is done fastest by switching off the measured value correction
Corr = 0
or setting the scaling parameters to a linear behaviour.
+
The values
InL.x and InH.x show the real measured value. The output values OuL.x and OuH.x start
with the preset value.
Calibrating level
TB 45
41
s
t
s
t
ф
ф
ф
ф
ф
ф
s
t
PASS
45.0
CAL
OuH.1
InH.1
InH.1
OuL.1
InL.1
InL.1
ô
InP.1
End
st
ô
InL.1
(
)
off
s
t
(
)
off