Audient iD22 - Manual (Page 20)

35 36
Cubase / Nuendo Set-Up
Operation with Cubase / Nuendo
Buffer sizes can be set in the control panel
within the VST devices display. It would be
ideal to keep them quite high to reduce CPU
loading if you use the iD22 mixer as the
input monitoring device while recording.
I/O ports can be renamed in the device
panel such that they better represent what
you connect to them (for example Main
Monitors, Alt. Monitors, Hardware Process
Loop). This is useful as any names chosen
here will be those displayed when assigning
i/o on track input/output channel routing.
Close the VST device setup panel and
navigate to the VST connections panel:
Devices > VST Connections (F4)
Here you can ensure that all buses have
been created in Cubase / Nuendo and
therefore all ports are addressable in your
session. Add new buses and assign them
to the necessary i/o if required.
Bus types can be set (mono / stereo) and
the VST control room section can also be
used. For more information regarding set-
up please consult your Steinberg user
manuals and documentation.
Ableton Live Set-up
Operation with Ableton Live
Once iD22 has been successfully installed
following the steps detailed on page 6 of
this manual, launch Ableton Live and head
straight to:
Live > Preferences
Here navigate to the Audio tab and make
sure that iD22 is assigned as the playback
device.
For more information
about setting up audio
i/o refer to your Ableton
Live user manuals &
documentation.
In the Live Audio Preference panel you can
set an appropriate buffer size (this can be
kept high if you are monitoring input signals
for recording via the iD22 low latency DSP
mixer. Ensure that iD22 reports as a 10-in,
14-out device to Live.
If necessary you can limit the number of
i/o channels reported as active inputs
(from the driver) in Live by using the
input
and output config tabs. This is an excellent
feature to help reduce CPU loading if all
channels are not required.