Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 6)

Trimble Ranger X Meter Reading System Software Installation
REMOVING PREVIOUS SOFTWARE VERSIONS
Before installing the new software, remove any older versions of the software that are on the handheld
The Factory Reset method (1) is recommended Read the descriptions below and choose the appropriate procedure based on
your handheld setup
1. Removing the Previous Software Using Factory Reset (Recommended)
Factory reset is the recommended method for removing the previous version of the meter reading software This
procedure resets the Trimble Ranger to "factory fresh" condition and removes all previously added software Refer to
"Removing Previous Software Using Factory Reset" on page 7
CAUTION: If you previously added software to the handheld that you do not want to remove, use the Alternative
method, "Removing Previous Software Using Remove Programs" on page 8
2. Removing the Previous Software Using Remove Programs (Alternative)
This procedure uses the Windows tool, "Remove Programs," for removing the previous meter reading software
version Remove Programs allows you to select the programs you want to remove It can be used when the handheld
has other software that you do not want to remove Refer to "Removing Previous Software Using Remove Programs"
on page 8
3. (Kiosk mode) Removing the Previous Software
For handhelds in Kiosk mode, use procedure 1, "Removing Previous Software Using Factory Reset" on page 7 to
remove previous Kiosk software and all other previously added software
If you previously added software to the handheld that you do not want to remove, use the instructions
"Removing
Previous Software from Kiosk Mode" on page 11
No Previous Software
If there is no previous version of the ORION meter reading software on the handheld, go directly to "Installing the Meter
Reading Software" on page 14
REMOVING PREVIOUS SOFTWARE VERSIONS
Page 6 July 2013