Badger Meter Gas Meter Endpoints - Manual (Page 3)

SUGGESTED TOOLS
VOM Multi-Meter (Analog) 59987-001
Coax Stripper 59989-001
Wire Cutting Pliers 59991-001
Wire Stripper 59993-001
Parallel Pliers 59983-001
TORX® #T-10 Driver
1/4" - 3/4" Vari-Bit (Newark 81N2636)
3/32" Transfer Punch
3/16" Transfer Punch
Double-Side Tape (3M 442PC)
62658-003
Table 1: Suggested tools
REQUIRED MATERIAL
OTEE: N Numbers in the first column correspond to the parts shown in Figure 3 on page 4
1 *Gasket (1) 62838-001
Parts marked with *
are included in the
Installation Kit
2 Outer cover
3 *TORX screws (4) 31820-026
4 *Gel connectors (2) 59761-001
5
*Ear clamp (1) 59759-001
*Ear clamp (1) 59759-002
— Transmitter wire (Belden 9802) not shown 59604-003
Table 2: Required materials
IDENTIFICATION
The Badger Meter Gas Recordall® Transmitter (Gas-RT) is available in two configurations: Clockwise Operation (CW) and
Counterclockwise Operation (CCW), as identified on the frame (looking toward the index), with the markings CW or CCW for
both configurations The Gas-RT should be installed so that the wire port is at the lower edge See Figure 1
Red/Black: Used with TRACE® Remote and Pit Transponders, Itron® ERT® Remote and Pit Transponders, and ORION® Pit and
Remote Transponders
Identification-
clockwise operation
Identification-
counterclockwise
operation
Figure 1: CW & CCW operation identification
The Gas-RT is available for a wide variety of gas meters See "Gas-RT Application Data" on page 6 for the correct unit
Before proceeding with installation, be certain the meter type conforms to the rotation for your Gas-RT and the proper Gas-RT
configuration, indicated above, has been supplied for the application
Installation Manual
Page 3 July 2014