Crystal XP2i 2nd Generation - Manual (Page 18)

Safety & Certifications  16
XP2i Operation Manual
Safety & Certifications
„ „
HaZardous LocatIons
Every XP2i pressure gauge includes the following Intrinsic Safety approvals:
II 1G Ex ia IIC T4
KeMa 04 ateX 1053 X
This product conforms to the following standards:
EN 60079-0 :
2006 | EN 60079-11: 2007 | EN 60079-26: 2007
Ex ia IIC T4
Iecex csa 05.0001X
This product conforms to the following standards:
IEC 60079-0 : 2004 | IEC 60079-11: 2006
Intrinsically Safe and Non-incendive for Hazardous Locations: Class I, Division 1
Groups A, B, C and D, Temperature Code T4.
!
WARNINGS: the following warnings apply to the XP2i:
•
do not use the rs-232 connector in hazardous locations.
•
replace batteries in non-hazardous locations and with approved types, only.
•
special conditions for safe use
•
Because the enclosure of the digital test gauge Model series XP2i and XP2i-dd is made of aluminium, if it is mounted in an area where the use of
category 1 g apparatus is required, it must be installed such, that, even in the event of rare incidents, ignition sources due to impact and friction
sparks are excluded.
„ „
certIFIcatIons
The XP2i has been tested and certified to comply with a variety of international standards.
This XP2i complies with the Australian requirements for the C-tick mark.
The instrument was tested against AS/NZS 3584, C-tick EMC/EMI requirements.
Crystal Engineering declares that the XP2i is in accordance with the ATEX Directive, the Electromagnetic Compatibility Directive, and the Pressure
Equipment Directive per our declaration(s).
This XP2i is approved for use as a portable test instrument for Marine use and complies with Det Norsjke Veritas’ Rules for Classification of Ships, High
Speed & Light Craft and Offshore Standards.
ATEX
CSA
C-tick